![]() ![]() D1 allows only dc to pass through the meter.Īlso depending upon what type of meter is used, it may require a potentiometer in series to prevent full scale deflection. You can select position 3 while the transistor is oscillation and it will stop the polarity reversals, so you can adjust oscillation pitch and gain settings. Using 12 volts can cause some transistors to have the “avalanche effect” and appear shorted. Avoid using any voltage higher than 9 volts in this circuit. These transistors will light both leds, when they are actually good. Some power transistors have an internal clamping diode, such as the ones used in tv flyback transformers. I have tested some power transistors with this circuit, like the 2N3055. If the diode is shorted, but leds will light. If the diode is good only led 2, or led 3 will light, but not both. It doesn’t matter which way you connect the diode. The polarity reversals occur much faster in position 1. To test a diode connect it across the E and C leads. If the transistor is shorted, both led2 and led3 will light and oscillations will not occur. Oscillations will occur if the transistor is good and the appropriate led will light. The base receives a portion of the collector voltage through VR2 and resistor R7. The first 555 sets the pulse rate to be about 1.5 seconds width in position 2. Some transistors testers require the use of a DPDT switch to reverse the polarity depending on NPN, or PNP type transistors. You have a positive and negative continuing reversal that is applied directly to the emitter and to the collector via the center tap of the transformer. The right side 555 output will always be opposite polarity from the left side 555 pulse. When the output pin 3 of the left side 555 goes low, the right side 555 pin 3 goes high. ![]() Meaning, when the output on pin 3 of the left side 555 goes high, the output pin 3 of the right 555 goes low. Referring to the transistor tester circuit diagram, when the 555 timer on the left puts out a positive pulse, it triggers the timer on the right to put out a negative pulse and vice-versa. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |